Metal Detectors Accessories
: Miscellaneous Parts
Bullseye II Pinpointer
Electronic Recovery Probe
When you've located a target and dug the hole, use the Bullseye II Pinpointer to precisely "pinpoint" the target. No tuning. Completely automatic. Works in either "vibration" or "beep" mode. Powerful LED light illuminates target areas when the button is pushed. Powered for up to 20 hours on a single 9-Volt battery.
P/N 812-0002
USD $119.95
+ Read more
When you've located a target and dug the hole, use the Bullseye II Pinpointer to precisely "pinpoint" the target. No tuning. Completely automatic. Works in either "vibration" or "beep" mode. Powerful LED light illuminates target areas when the button is pushed. Powered for up to 20 hours on a single 9-Volt battery.
Works side by side with our detectors. It's easy. It's fast. Just locate the target with your detector, push the button and "zero in" on the target's exact location. No tuning. Completely automatic. Works in either "vibration" or "beep" mode. Powerful LED light illuminates target areas when the button is pushed. Powered for up to 20 hours on a single 9-Volt battery.
Bullseye II Pouch
Protects the Bullseye II from mud and moisture. Conveniently clips on to your belt or pocket. Pouch stays on continuously during use.
P/N 601-1216
USD $9.95
Vibra-Probe 580
Now with Manual - shut off capability!
No push button switches. The Vibra-Probe 580 uses our unique tilt-on/off technology in addition to our traditional one-minute automatic-off battery saver. This translates into faster recovery times and longer battery life.
The only pinpointer with tip only detection, so you know precisely where the target is.
$149.95
+ Read more
No annoying buzzers! The Vibra-Probe is the original pinpointer that communicates with vibration. It alerts only you that you've found a target.
Never worry about dirt, dust, mud or water because our unique sealed design is airtight and waterproof to a depth of 100 feet.
No fumbling with knobs! The Vibra-Probe 580 is fully automatic. The self-calibrating microprocessor-controlled circuitry requires no adjustments of any kind.
The included belt holster makes it easy to carry and always at the ready.
- Pulse Induction (PI) technology
- Tilt on & off
- Tip-only detection
- Communicates with vibration
- Automatic calibration
- Low-battery indicator
- Waterproof - Submersible to 100 feet (30 meters)
- Auto-off (after one minute) battery saver
i-detect Metal Detecting Journal
New! Treasure Hunting Database CD-ROM. Record your finds, locations, and detector settings in one program. Customize the screens for your detector. Search by location, type of find, and more. Organize and tally your treasures. Easy install. For Windows '98 and higher.
P/N 601-1214
USD $24.95
Diver Rod Kit
Converts handheld Surfmasters to short rod for scuba use.
P/N 802-5195-1
USD $39.95
Detector Stand for DFX™, XLT®, MXT™, and M6
Mounts to control box using existing control box screws. Keeps control box out of wet grass and off abrasive ground.
P/N 502-0028
USD $4.95
Gold Pan
Maroon plastic gold pan allows easy view of black sands and gold. Large 15" size with 3 layer built in ripples on one-third of pan edge.
P/N 601-0151-1
USD $12.95
Space Saver Rod Kit
Converts Classics and early Goldmaster models from the standart two-piece rod assembly to a three-section assembly for tighter packing. (Does not fit Classic SL series instruments.)
P/N 802-5236
USD $39.95
Long Handled Sand Scoop
Handheld convertible (Short / Long) Sand Scoop. Spring Clip disassembles for travel/storage.
P/N 601-0069
USD $59.95
8" Coin Probe
8" steel shaft with brazed ball bearing tip. 4" wire wrapped wood handle.
P/N 601-1128-1
USD $12.95
Digging Trowel
Dayglow yellow rubber handle. Six and one-half inch stainless steel blade with inches labeled.
P/N 601-1145-1
USD $12.95
Treasure Hunt Apron
White canvas material with White's logo and separate trash and treasure pouches.
P/N 601-0024
USD $3.95
Weather Beater (DFX™, XLT®, QXT)
Detector cover. Resistant to water and dirt. Fits XLT and Quantums. (one piece)
P/N 601-1155
USD $14.95
Hipmount Kit (DFX™, XLT®, QXT)
Fits DFX, XLT, QXT. Mounts to existing control box screws. Keeps control box off abrasive ground.
P/N 802-5260
USD $59.95
Surf Master PI and Beach Hunter ID "O" Ring
Replacement "O" ring seal for main control box lid.
P/N 527-0043
USD $4.95
Full Size Digging Pouch
Separate pouches for trash, treasure, and additional digging tools. (Belt not included)
P/N 601-0066
USD $14.95
Lesche/Whites Digging Tool
Ultimate trowel. Heat tempered, serrated edge. Sheath included.
P/N 601-0067
USD $49.95
License Plate Cover
White's license plate cover. Automobile bling bling.
P/N 601-1226
USD $19.95
Arm Cup Foam Pad Kit
Pair of foam pads for all White's Arm Cups (elbow supports). Peel and stick.
P/N 802-5309
USD $1.00